evelynwww.support.xbox.com – How to fix Xbox One Controller Drift issue
When an Xbox One controller starts to drift, the gamer frequently feels unwanted movement when using the device to play games. This issue is known as controller drift, sometimes known as analog stick drift, since one or both of the thumbsticks may drift or move in an unfavorable direction even when you are not touching them.
The Xbox One controller’s drifting can be attributed to three main issues: a broken thumbstick pad, broken springs, and a poor thumbstick unit. You will need to disassemble the controller to repair or replace one or more of the parts attached to the analog sticks to resolve the Xbox One Controller Drift. So, read on and carefully follow the instructions provided to learn more about the issue’s solution.
HOW TO FIX XBOX ONE CONTROLLER DRIFT ISSUE
- Xbox One Controller Drift may require a few different fixes, so be prepared to explore. Follow the methods and solutions provided below to learn how to solve them.
Solution #1: Replace Thumbstick Pads
- Pull back the thumbstick and use alcohol to gently wipe the rounded surface clean. The cleaning will be finished at this point.
- You can completely clean the entire device by turning the thumbstick in tiny increments.
- After the thumbstick has been fully cleaned, check its operating capabilities by running a test down its whole length.
- If the thumbstick still sticks or drifts after you’ve tried to fix it, disassemble your Xbox One controller using a pry tool and a T-8 or T-9 safety Torx.
- The thumbsticks should be moved. To check if they are securely fastened, perform this. After that, make sure they are in the appropriate positions before using them.
- Remove the thumbstick pads from the controller if they feel sloppy.
- Check to see if the thumbstick pads have moved. You can either replace them with new ones or reattach them using a shim made of a thin piece of paper or plastic.
- Check to determine whether the pads have gotten loose or if they have become displaced.
- After the controller has been reassembled, run a performance evaluation.
Solution #2: Fix the Thumbstick Springs
- Using a prying tool and a T-8 or T-9 safety Torx screwdriver, you should first disassemble your controller.
- From the bottom and right side of the thumbstick assembly, gently peel off the green plastic covers. These coverings are positioned on the assembly’s right side.
- Take the springs out of the frame where they are attached.
- You can swap out the springs for new ones or ones that were removed from a different controller.
- Replace the green plastic safety covers in their original placements after that.
- Reassemble your controller and verify that it is still operating properly.
Solution #3: Replace the Analog Stick
- You’ll need a T-8 or T-9 safety Torx and a pry tool to disassemble your controller. A T-7 Torx is also required to remove the circuit board. By utilizing the T-8 or T-9 safety Torx, the casing can be disassembled.
- A desoldering tool is required to remove the old analog stick assembly from the circuit board.
- Solder the replacement analog stick assembly into place after insertion to ensure that it won’t move.
- Perform a performance test following the controller’s reassembly.
Conclusion: The most frequent problem is Xbox drift in the left analog stick, which manifests itself frequently in first-person games as your character always looking up. On the other side, drift issues could also exist with the right stick. You should also be aware that when you move one of the analog sticks, it will continue to register that movement even if your thumb is removed from the stick. The analog sticks’ pressure sensitivity is the source of this. To solve Xbox One Controller Drift at home, follow these steps.
